A leak you can see gets dealt with first
If water is dripping from a ceiling, a supply hose is weeping under the sink or a wet patch is spreading along a basement wall, start with the closest valve. Most sinks and toilets have a small shut-off underneath. Turn it clockwise until it stops.
No valve, or it will not move? Shut the main where the water line comes into the basement, next to the meter. If that valve has not been turned in years it may only close part of the way. Do not force it with a wrench. Next, open a cold tap on the lowest floor so the lines empty. If water is near a light or an outlet, switch off that breaker and keep away from it.
A slow drip can wait for a booked visit. A split pipe or water coming through a ceiling cannot. Call it in as an emergency.
January freezes the pipe nearest the cold
The Fergus Shand Dam weather station records about 30 January days at or below freezing, about 16 of them below -10 °C. Pipe freezes where it runs along an outside wall, through an unheated space or out to a hose tap.
The Victory homes on Churchill Crescent, Edinburgh Avenue, Forfar Street and James Street were built between 1948 and 1954. Many sat on concrete blocks with no basement. Their water lines run through crawl spaces or through basements dug out later, and those are the pipes that freeze. The plumber finds the frozen length, checks for splits once it thaws, and then reroutes, insulates or adds heat so it does not freeze again.
Outdoor taps split when water is left standing in them. In the fall, close the valve inside, open the outside tap and let it drain. If the tap drips all winter or leaks inside the wall in spring, it needs replacing.
Frost can also reach the water service under the yard. The Township says some older service lines were laid less than 2.0 metres deep. New lines go at 2.0 metres. The owner is responsible for the pipe from the house to the property line. If your line has frozen, the Township may ask you to keep a cold tap running, using one that does not feed through the water softener. Where a line has frozen before, the Township's view is that lowering it is the best fix.
Hard water wears out taps, toilets and valves
The Township reports Fergus water at 540 mg/L hardness, or 38 grains. That much mineral leaves scale on anything with small openings or moving parts. You will see a toilet that refills on its own, a tap that keeps dripping after a new washer, a shower head spraying sideways and shut-off valves that seize.
The newer houses in Storybrook, off Beatty Line, were plumbed with PEX supply lines and plastic drains. The pipe itself rarely fails. Most of the repair calls there are scale: fill valves, cartridges, aerators and valves crusted up after only a few years. Older houses get the same scale on top of their older pipe.
When a shower or tub valve is replaced, the temperature is set as well. Ontario's Building Code caps water from a shower head or into a bathtub at 49 °C, and the valve's limit stop is set to that. A softener slows scale on every fixture. See the hard water guide for how it affects the tank as well.
Galvanized and lead pipe in the oldest houses
The limestone row on St. Andrew Street went up between 1857 and 1908, with more old houses on St. Andrew Street West and Union Street West. Houses of that age in Ontario were usually supplied through galvanized steel pipe, and some through lead.
Galvanized pipe rusts from the inside until the bore narrows. The signs: a weak flow upstairs while downstairs is fine, brown water first thing in the morning, and leaks at the threaded joints. A magnet sticks to it. Lead does not hold a magnet. It is dull grey, bends rather than threads, and a key scraped across it leaves a bright mark. You usually find it where the service enters the house, before the meter.
If you think there is lead, have the water tested. Ontario's drinking water standard for lead is 0.010 milligrams per litre. The section from the house to the property line belongs to the owner, so replacing it is the owner's job too. Patching one galvanized joint can buy time, but the rest of the run is just as old. The plumber tells you which you have and how much of it is left.
How a repair visit goes
Tell us what the water is doing and where. At the house the plumber shuts off the right section, looks at what the pipe is made of and how far the problem goes, and explains what has failed. You get the price in writing and approve it before any part goes in. If a cheap repair will hold, you hear that. If the pipe on either side will not, you see it for yourself.
Running new supply pipe, extending lines and changing drains generally need a building permit under the Building Code Act. The Township's building department decides on each job, and the plumber will tell you when one is likely. Work is performed by licensed plumbers (306A Certificate of Qualification).
For a planned job, such as replacing an old service or a run of galvanized pipe, ask for a written quote. Blocked drains are covered under drain cleaning.
